Cable Box or Satellite box usage —– (LEFT SIDE of unit) -> RF INPUT not used
Connect the SKCR2706BT-B via AV cables or HDMI (LEFT SIDE of unit) (AV cables use # 2, 3 and 4 inputs) + (HDMI #5 input).
Then select AV signal source by pressing the source key (key # 30) on the remote
>> Option 1 for connection -> LINE IN connect and use RCA AV cables (Yellow, Red and White)
>> Option 2 for connection -> HDMI PORT-> use HDMI CABLE (Cable Box or Satellite box needs to be set to 1080p output)
Digital Antenna usage REAR SIDE of unit -> RF INPUT
If you are using Digital antenna –
Please refer to page 5 of the manual to confirm connection to the RF IN input (# 8 input)
Please note to use the RF IN on the REAR SIDE of the unit. Then proceed to perform the channel scan.
If you are using an HDMI cable – then connect it via HDMI first and select HDMI source.
– If SKCR2706BT-B shows no signal, then connect the Cable Box or Satellite box to another TV 1st and to call cable/satellite company to setup the output to 1080p
– Once the Cable Box or Satellite box is set to output to 1080p – it can then be used with the SKCR2706BT-B via AV signal source.
>> Please check and confirm if the service provider box resolution settings are set to 720P
>> Please call your service provider if needed – for assistance in changing the settings on your cable/satellite box to 720P
1st confirm what signal source you are using
– Digital Antenna?
– Cable Box or Satellite box?